Description
Moving 7-Segment Display
In this part of the lab, you are to modify the seven-segment display design from Lab 3 so that when
a button is pressed, the next digit is displayed. The following figure provides some illustrations. For
example, if the board is currently displaying the rightmost digit (whatever the value shown may be),
pressing a button (BTN0) will cause the second rightmost digit to light up instead (with the same value
shown). Pressing a button when the leftmost digit is displayed will cause the rightmost digit to light up.
Note that we want the system to remember its state so you need to implement this part of the lab as
a sequential circuit (otherwise, releasing the button will cause the rightmost digit to be displayed again
1
regardless of the current state of the system). Use your FSM to guide you. Recall that a sequential
circuit needs a clock and a reset. Modify your SevenSeg.v file appropriately using the following declaration: SevenSeg(clk0 , rst, button, w, x, y, z, a, b, c, d, e, f, g, n3, n2, n1, n0). When
the reset button rst is pressed, the digit that will be displayed is the rightmost digit (we assume the
rightmost digit represents the initial state of the FSM). All operations are synchronous.
Test your design using simulations before moving on. Once you are convinced your design is correct,
switch to implementation mode and create an appropriate .ucf file. Select CLK1 as your clock input,
BTN0 as your button input, and BTN1 as your rst input. Before you generate a bit file make sure that the
following considerations are taken care of.
First, the Basys board gives you three options for clock frequency: 25Mhz, 50Mhz, and 100Mhz. With no
blue jumper, the clock frequency is 50Mhz. If the blue jumper is on the low position, the clock frequency
is 25Mhz. Otherwise, it is 100Mhz. For this lab, we will use 50Mhz so there is no jumper needed.
Second, the board clock frequency is way too fast for the human eye. For this reason, you will need to
use a clock divider to slow down the frequency (refer to p. 219 of your main textbook for a discussion
on this topic). A clock divider (clockdivider.v) is provided for your use in Canvas. Download it and
use the output of the clock divider as the input clk to your FSM. With the clock divider, the output
clock now ticks once every second. This means that you may need to hold your button for a little while
before changes occur. Don’t forget to test your reset button. Show the results to the TA.
3 Sophisticated 7-Segment Display
Modify your moving 7-segment display design to increase the displayed value by one every time a count
button is pressed. An example is given below. The initial value should be set to 0. If the currently
displayed value is F, the next value should be 0. Use BTN2 as the count button. It may be easier to use
two FSMs instead of one to implement this design.
Challenge (Optional): Instead of using the count button to increment the displayed value, design
your system so that every time button is pressed, the display moves and increases the displayed value
by one.
4 TA Checkoff
• (20 points) Prelab.
• (90 points) Moving 7-segment display.
• (90 points) Sophisticated 7-segment display (either the standard or more challenging version).
2
